Page 1 of 1
ParaView for Elmer in Ubuntu 18.04 LTS
Posted: 09 Jul 2021, 09:59
by shandilya62
Hi Shandilya here,
I have installed Elmer in my ubuntu 18.04 LTS but Paraview is not there in the elmer. So I have separately installed Paraview, now how can i connect paraview to the Elmer?
Please give any method. Pleae somebody help me with this.
Forgive me if I have written anything wrong.
Re: ParaView for Elmer in Ubuntu 18.04 LTS
Posted: 09 Jul 2021, 12:46
by kevinarden
You can open paraview and from paraview open the *.vtu created by Elmer.
If Elmer did not create one then you need a post file in your simulation section
Simulation
Post File = case.vtu
End
In ElmerGUI it just tries to start paraview by issuing the command paraview. If paraview is not in your path GUI can't start it.
Re: ParaView for Elmer in Ubuntu 18.04 LTS
Posted: 09 Jul 2021, 15:20
by shandilya62
Thank you kevinarden,
Could you please guide me how to add that paraview in GUI path please.
Re: ParaView for Elmer in Ubuntu 18.04 LTS
Posted: 09 Jul 2021, 16:45
by kevinarden
Would have to start with what operating system you are using, path is a system variable.
Re: ParaView for Elmer in Ubuntu 18.04 LTS
Posted: 09 Jul 2021, 16:46
by kevinarden
Re: ParaView for Elmer in Ubuntu 18.04 LTS
Posted: 09 Jul 2021, 17:09
by kevinarden
Re: ParaView for Elmer in Ubuntu 18.04 LTS
Posted: 09 Jul 2021, 21:40
by shandilya62
Thank you very much kevinarden
You really helped me out thank you so much.