Page 2 of 2
Re: Checking if my geometry is correct
Posted: 12 Jul 2021, 20:20
by lmehdizadegannam
gmsh.
Re: Checking if my geometry is correct
Posted: 12 Jul 2021, 20:28
by kevinarden
To unit the edges in gmsh use the coherence command.
Re: Checking if my geometry is correct
Posted: 14 Jul 2021, 14:34
by lmehdizadegannam
Hi Kevin,
Thanks for all your help. I still have difficulty with gmsh. I want to have a cylinder (30.5 in y direction, radius 7.62). The cylinder is non-hollow and I want to mesh it somehow that it has nodes less than 80. I previously did that in the wrong direction. Now I cannot generate the right geometry. Can you help me? Thanks so much!
Re: Checking if my geometry is correct
Posted: 14 Jul 2021, 14:41
by lmehdizadegannam
This is the geometry I generated before. I meant to assign 30.5 to y direction not x. Somehow I cannot regenerate this.
Re: Checking if my geometry is correct
Posted: 11 Nov 2021, 08:41
by rebaz
I think there is nothing wrong with that