Dear Elmer Users,
Elmer software suite includes two different tools for postprocessing. However, these are not always sufficient for the intended use. Therefore people use a large variety of different postprocessing tools. To get an overall picture of the most commonly used tools would be interesting and hence I decided to put up this poll. Also if you are using some unsupported visualialization software for which you would like to have a output format, this would be a good place to cast the votes.
-Peter
What visualization software do you use?
Re: What visualization software do you use?
I need to start using ParaView, but for now I mostly use SALOME when I can.
-Jake
Hazudra Fodder
Hazudra Fodder
Re: What visualization software do you use?
I use Tecplot. Is there any way to get Elmer output into Tecplot?
Cheers,
Frank
Cheers,
Frank
-
- Site Admin
- Posts: 4838
- Joined: 22 Aug 2009, 11:57
- Antispam: Yes
- Location: Espoo, Finland
- Contact:
Re: What visualization software do you use?
Hi Frank
Does Techplot read any format with publically available format specifications? Link to the specs is a good starting point for adding such features.
-Peter
Does Techplot read any format with publically available format specifications? Link to the specs is a good starting point for adding such features.
-Peter