I performed a simulation where I used the FluxSolver to calculate the flux from an electrostatic potential (StatElecSolver). To understand the results,
- what is the unit if the result "potential flux"
- what is the recommended input for "Flux Coefficient"?
thanks and regards
Uwe
What is the unit of the potential flux?
Re: What is the unit of the potential flux?
OK, it should be V*A/m^2 or W/m^2.
However, I still need to know what I can specify as Flux Coefficient. it must be a term describing a constant with the unit A/m.
Edit: the potential times the electric conductivity has the unit A/m but how do I input this for the Flux Coefficient?
However, I still need to know what I can specify as Flux Coefficient. it must be a term describing a constant with the unit A/m.
Edit: the potential times the electric conductivity has the unit A/m but how do I input this for the Flux Coefficient?
Elmer in FreeCAD : https://wiki.freecadweb.org/FEM_SolverElmer