I am using the 'Smart Heater Control' in a transient simulation to keep the temperature of a body at a constant temperature. I would like to output the heat source (W/kg) of that body. I went through the forums and I think it was Peter that suggested using the SaveData module using the 'Body Force Parameters' subroutine. I am having trouble getting it to work and cannot find a working example of it.
I am sure this is a mess:
Code: Select all
Solver 4
Procedure = "SaveData" "SaveBoundaryValues"
Variable = -nooutput dummyvar
Variable DOFs = 1
Parameter 1 = Heat Source
Body Force Parameters = 1
End
With this I keep getting:
Code: Select all
ERROR:: LoadInputFile:
ERROR:: LoadInputFile: Unknown specifier: [1]
ERROR:: LoadInputFile: In section: [solver 4]
ERROR:: LoadInputFile: For property name:[body force parameters]
STOP 1
Is there any other way to output the heat source value for each time step?
Thanks,
Chips