Generating visible waves from an acoustic waveguide

General discussion about Elmer
kevinarden
Posts: 1169
Joined: 25 Jan 2019, 01:28
Antispam: Yes

Re: Generating visible waves from an acoustic waveguide

Post by kevinarden »

Elmer itself is unitless, but your material constants are SI so length should be meters.
In the unv file node 1 is 50.8, 50.8, node 6 is 50.8, -50.8
node 2 is 0, 9.5625 and Node 5 is 0, -9.525
so scaling by 0.001 would give mm
-1
2411
1 1 1 11
5.0799999999999997D+01 5.0799999999999997D+01 0.0000000000000000D+00
2 1 1 11
8.5635224561320102D-15 9.5250000000000004D+00 0.0000000000000000D+00
3 1 1 11
5.0800000000000303D+01 2.0000000000000000D+03 0.0000000000000000D+00
4 1 1 11
5.0799999999999699D+01 -2.0000000000000000D+03 0.0000000000000000D+00
5 1 1 11
6.2305702972287401D-15 -9.5250000000000004D+00 0.0000000000000000D+00
6 1 1 11
5.0799999999999699D+01 -5.0799999999999898D+01 0.0000000000000000D+00
Gary R
Posts: 108
Joined: 12 Apr 2012, 07:23
Antispam: Yes
Location: Long Beach CA, USA

Re: Generating visible waves from an acoustic waveguide

Post by Gary R »

OK I'm confused. Attached are two screen shots of the solution at 2000 Hz. One is of the magnitude and the other of the X vector only. The magnitude shows very little in the way of wave motion. The X vector shows strong periodic wave motion and corresponds to the proper number of waves for the 2 m distance of the model. The Y vector seems to be exactly out of phase with the X vector leaving the magnitude equal to zero. I am not sure how to interpret this. Associating X and Y pressure vectors with X and Y Cartesian measurements is not computing well in my brain. It would seem that the magnitude would be the only thing of importance as far as sound volume is concerned. If that is true then the output of the waveguide is essentially zero. I find that hard to believe. At 3KHz the simulation starts to fail, which was pointed out earlier.

Comments would be sincerely appreciated.

Gary R.
Attachments
Helmholtz2000X.png
X vector only
(198.66 KiB) Not downloaded yet
Helmholtz2000Mag.png
Magnitude of X and Y vectors
(120.68 KiB) Not downloaded yet
raback
Site Admin
Posts: 4141
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

Re: Generating visible waves from an acoustic waveguide

Post by raback »

Hi

Paraview does not support complex numbers so you should think of _x as the Real component and _y as the Imaginary component.

-Peter
Gary R
Posts: 108
Joined: 12 Apr 2012, 07:23
Antispam: Yes
Location: Long Beach CA, USA

Re: Generating visible waves from an acoustic waveguide

Post by Gary R »

Thanks Peter. Makes sense. I guess the only thing left to do is adjust the mesh for higher frequencies.

Gary R
Post Reply