DIFFERENT FILES.VTU OUTPUT: ADAPTING MESH PROBLEM WITH FREESURFACE SOLVER

Numerical methods and mathematical models of Elmer
Post Reply
Andrea_P
Posts: 176
Joined: 22 Mar 2021, 18:39
Antispam: Yes
Location: POLYTHECNIC UNIVERSITY OF TURIN

DIFFERENT FILES.VTU OUTPUT: ADAPTING MESH PROBLEM WITH FREESURFACE SOLVER

Post by Andrea_P »

Good morning dear community,
My case.sif produces two types of file.vtu when I run it; one in the "RefinedMesh" where the mesh refines but without the velocity and free surface evolution that I expect and the other .vtu where the mesh does not change but the physical properties evolution is right. How can I unite the two vtu types? Why does this problem occur?
Thanks for your answers.
Regards,
Andrea
Attachments
rettangolo_0.1_x_0.15_raffianto_con_triangoli_grezzo.msh
(1.69 KiB) Downloaded 134 times
case.sif
(4.78 KiB) Downloaded 137 times
POLYTECHNIC UNIVERSITY OF TURIN-DIMEAS
raback
Site Admin
Posts: 4812
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

Re: DIFFERENT FILES.VTU OUTPUT: ADAPTING MESH PROBLEM WITH FREESURFACE SOLVER

Post by raback »

Hi Andrea

The main problem seems to be that FreeSurfaceSolver is not updated after the mesh is changed. The variable still points to the one of the original mesh. Sorry for that. Probably FreeSurfaceSolver has not been done with adaptivity that much....

-Peter
Andrea_P
Posts: 176
Joined: 22 Mar 2021, 18:39
Antispam: Yes
Location: POLYTHECNIC UNIVERSITY OF TURIN

Re: DIFFERENT FILES.VTU OUTPUT: ADAPTING MESH PROBLEM WITH FREESURFACE SOLVER

Post by Andrea_P »

Hi Peter,
Thanks for your rapid answer.
Andrea
POLYTECHNIC UNIVERSITY OF TURIN-DIMEAS
Post Reply