Good morning dear community,
My case.sif produces two types of file.vtu when I run it; one in the "RefinedMesh" where the mesh refines but without the velocity and free surface evolution that I expect and the other .vtu where the mesh does not change but the physical properties evolution is right. How can I unite the two vtu types? Why does this problem occur?
Thanks for your answers.
Regards,
Andrea
DIFFERENT FILES.VTU OUTPUT: ADAPTING MESH PROBLEM WITH FREESURFACE SOLVER
-
- Posts: 176
- Joined: 22 Mar 2021, 18:39
- Antispam: Yes
- Location: POLYTHECNIC UNIVERSITY OF TURIN
DIFFERENT FILES.VTU OUTPUT: ADAPTING MESH PROBLEM WITH FREESURFACE SOLVER
- Attachments
-
- rettangolo_0.1_x_0.15_raffianto_con_triangoli_grezzo.msh
- (1.69 KiB) Downloaded 138 times
-
- case.sif
- (4.78 KiB) Downloaded 140 times
POLYTECHNIC UNIVERSITY OF TURIN-DIMEAS
-
- Site Admin
- Posts: 4812
- Joined: 22 Aug 2009, 11:57
- Antispam: Yes
- Location: Espoo, Finland
- Contact:
Re: DIFFERENT FILES.VTU OUTPUT: ADAPTING MESH PROBLEM WITH FREESURFACE SOLVER
Hi Andrea
The main problem seems to be that FreeSurfaceSolver is not updated after the mesh is changed. The variable still points to the one of the original mesh. Sorry for that. Probably FreeSurfaceSolver has not been done with adaptivity that much....
-Peter
The main problem seems to be that FreeSurfaceSolver is not updated after the mesh is changed. The variable still points to the one of the original mesh. Sorry for that. Probably FreeSurfaceSolver has not been done with adaptivity that much....
-Peter
-
- Posts: 176
- Joined: 22 Mar 2021, 18:39
- Antispam: Yes
- Location: POLYTHECNIC UNIVERSITY OF TURIN
Re: DIFFERENT FILES.VTU OUTPUT: ADAPTING MESH PROBLEM WITH FREESURFACE SOLVER
Hi Peter,
Thanks for your rapid answer.
Andrea
Thanks for your rapid answer.
Andrea
POLYTECHNIC UNIVERSITY OF TURIN-DIMEAS