Request: Feasability of acoustic reflection setup

A forum for commercial service requests and offerings
Post Reply
wengen
Posts: 1
Joined: 17 Sep 2012, 13:26
Antispam: Yes

Request: Feasability of acoustic reflection setup

Post by wengen »

Hi,

I'm trying to use Elmer for a relatively simple acoustics case, but being new to this I fear I'm not going to finish it on time with the assurance of correctness. I'm interested to know if one of you would be available to setup a simulation.
For an indication, please find attached an image of the geometry (from ElmerGUI; length 30m), where the red surfaces are reflective, and the others are open boundaries. The desired output is the sound level at a certain point with a point source at the origin, for roughly 200-2000Hz. it would be great if we could then take the setup and experiment with different geometries. The goal is to see if this reduced parabolic reflector [1] with holes would still work.
Our budget is not too big, but if you're versed in Elmer I think this should not be such a hard case.
Looking forward to your response by private message.

Kind regards,
- Willem

[1] http://www.sfu.ca/sonic-studio/handbook ... ector.html
Attachments
geometry.png
geometry.png (29.42 KiB) Viewed 7132 times
Post Reply