Hello. Long time.
I've opened ElmerGUI.
Added a rectangular prism as my body.
Set it's Equation, Material, I.C., B.C., and most interestingly it's body force as a custom written fortran90 file.
Withholding detail, after I run the solver, and open ParaView.
I noticed I only have 1 .vtu file.
I was hoping to just simulate a few seconds worth of applying some force to my rectangle as an example.
Could anyone help me figure out what I am doing wrong?
Sincerely,
Renzo
Not getting data to view in ParaView after sim?
-
- Posts: 57
- Joined: 14 Mar 2021, 21:01
- Antispam: Yes
-
- Posts: 2319
- Joined: 25 Jan 2019, 01:28
- Antispam: Yes
Re: Not getting data to view in ParaView after sim?
Model setup did you change to transient and specify the time step and number of steps?
Steady Sate is the default.
Steady Sate is the default.
-
- Posts: 57
- Joined: 14 Mar 2021, 21:01
- Antispam: Yes
Re: Not getting data to view in ParaView after sim?
Yesss. Thank you kevinarden