postprocessor format conversion

Mesh generators, CAD programs, and other tools
Post Reply
mark smith
Posts: 215
Joined: 26 Aug 2009, 18:20
Location: Peterborough, England

postprocessor format conversion

Post by mark smith »

Hi
I currently use the ResultOutputSolver to output results in GiD format & wondered if there was a method of converting this into vtk or GMSH format without running the solver again?
Regards
mark
raback
Site Admin
Posts: 4812
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

Re: postprocessor format conversion

Post by raback »

Hi Mark

Sorry, this is not possible at least within Elmer suite. There could perhaps be some other converters between these formats but I'm not aware of such.

-Peter
mark smith
Posts: 215
Joined: 26 Aug 2009, 18:20
Location: Peterborough, England

Re: postprocessor format conversion

Post by mark smith »

Hi Peter
Thanks for the reply, I haven't managed to find a format converter so I suppose I'll have to write my own ;-(
I'll make it available once it's ready.
Regards
mark
Post Reply