Hello,
i´ve got a little problem using Paraview out of Elmer Gui.
I use Elmer 8.4-7b58366a and ParaView 5.8.0-RC2-Windows-Python3.7-msvc2015-64bit.
I can start Paraview out of Elmer Gui but the output file is named "case_0001.vtu" but paraview is looking for "case0001.vtu ".
I only found in the Setup Setting of the Gui the opportunity to set the name but not the underscore.
Where can i change, that the underscore is set?
Thx for reading.
Problem Paraview Integration into Elmer Gui
-
- Posts: 5
- Joined: 11 Feb 2020, 21:32
- Antispam: Yes
-
- Posts: 2418
- Joined: 25 Jan 2019, 01:28
- Antispam: Yes
Re: Problem Paraview Integration into Elmer Gui
you can install paraview for windows independent of elmer and open any file you want.
Once you open paraview, even from elmer, you can do a file open and select the file you want to open.
Elmer has changed the format that it is renaming vtu files.
Once you open paraview, even from elmer, you can do a file open and select the file you want to open.
Elmer has changed the format that it is renaming vtu files.
-
- Posts: 2418
- Joined: 25 Jan 2019, 01:28
- Antispam: Yes
Re: Problem Paraview Integration into Elmer Gui
you can also control the file naming convention by using quotations instead of the default
Post File = "case.vtu"
in the simulation section produces
case0001.vtu
etc.
Post File = "case.vtu"
in the simulation section produces
case0001.vtu
etc.
-
- Posts: 5
- Joined: 11 Feb 2020, 21:32
- Antispam: Yes
Re: Problem Paraview Integration into Elmer Gui
Hi,
thx for your replay
I tried using quotations, but with no luck.
the output postfile was still named: "case_t0001.vtu".
thx for your replay
I tried using quotations, but with no luck.
the output postfile was still named: "case_t0001.vtu".
-
- Posts: 2418
- Joined: 25 Jan 2019, 01:28
- Antispam: Yes
Re: Problem Paraview Integration into Elmer Gui
I was in a earlier version, in the latest version the "_t" is hard coded into the code.
-
- Posts: 5
- Joined: 11 Feb 2020, 21:32
- Antispam: Yes
Re: Problem Paraview Integration into Elmer Gui
ah ok well then i´ll use paraview in the standalone way.
But thx for your help
But thx for your help