tmd63 wrote:I had a look at Salome. I am on a windows 7 system. I noticed there are only linux/unix installs listed. So maybe it is not so easy to get Salome to work for me.
I already almost finished phase 1 of the project. If you are interrested please follow my progress on the FreeCAD forum in my activity log: https://forum.freecadweb.org/viewtopic. ... 88#p174988. There will be something to play around with later this week. Comments and ideas are always welcome
Hi Wil,
The works of Markus regarding the GSoC -work in the freecad forum are noteworthy from the perspective of GUI interfacing of Elmer Run with FreeCad.
Cheers,
Yours Sincerely,
Anil Kunwar
Anil Kunwar
Faculty of Mechanical Engineering, Silesian University of Technology, Gliwice
Let me post here some preliminary results produced with the work of Markus, since the GSoC is almost over. See also https://forum.freecadweb.org/viewtopic.php?f=18&t=22576 and https://github.com/drhooves/FreeCAD/tree/femnewsolver
By using Elmer it is now also possible to simulate fluid flow combined with heat in FreeCAD.
The model, including the geometry, the mesh and the constraint-set-up is completely done in FreeCAD.
It is the 3D equivalent of the non-gui Tutorial 4 "Compressible flow passing a step" in the "FlowStepCompressible" directory.
BR Wil