after having downloaded from GitHub, I've tried to run the test RotatingBCMagnetoDynamicsGeneric found in
https://github.com/ElmerCSC/elmerfem/tr ... icsGeneric
and had a fail.
I'm using Elmer on VM on a Mac. I've run all the commands required to build the mesh before starting the test. Below is the list of what I typed
Code: Select all
ElmerGrid 14 2 mortar_quarter.msh -autoclean
ElmerGrid extrude_quarter.eg
ElmerSolver
Code: Select all
ERROR:: IterSolve: Failed convergence tolerances.
Code: Select all
WARNING:: CompareToReferenceSolution: Solver 2 FAILED: Norm = 4.12269261E-03 RefNorm = 4.12179248E-03
CompareToReferenceSolution: Relative Error to reference norm: 2.183837E-04
The complete output of ElmerSolver is attached below About, the output, the case_mod.sif file that you will see is simply a copy of case.sif (a precaution to avoid altering the original)
If anyone can give me hand to understand why it's not working it would be much appreciated
Regards,
Marco