Hi Elmer team,
when I have the serial mesh files mesh.boundary mesh.elements etc I can use elmergrid to produce a vtu file of the mesh using
elmergrid 2 5 mesh
now for example if I partition the mesh into 8 parts & produce a directory partition.8 is it possible to produce a vtu file of this partitioned mesh? If so how?
for a coupled CFD+thermal simulation I'd like to see how the mesh is partitioned before running the solver so I can ensure I always have some of the fluid in each partition otherwise some of the solvers can fail when writing results.
Regards
Mark
elmergrid to produce vtu file from partitioned mesh
-
- Posts: 215
- Joined: 26 Aug 2009, 18:20
- Location: Peterborough, England
-
- Site Admin
- Posts: 4826
- Joined: 22 Aug 2009, 11:57
- Antispam: Yes
- Location: Espoo, Finland
- Contact:
Re: elmergrid to produce vtu file from partitioned mesh
Hi Mark
Try just giving the vtu option when doing partitioning, e.g.
ElmerGrid only writes parallel meshes it does not read them
-Peter
Try just giving the vtu option when doing partitioning, e.g.
Code: Select all
ElmerGrid 2 5 meshdir -metis 8 3 -partdual
-Peter
-
- Posts: 215
- Joined: 26 Aug 2009, 18:20
- Location: Peterborough, England
Re: elmergrid to produce vtu file from partitioned mesh
Hi Peter,
Works a treat
Thank you.
Regards
Mark
Works a treat
Thank you.
Regards
Mark