Hi,
I am trying to simulate a model in Elmer with some very small parts. I try to export it as .IGES but it is not working. It is opening the model in the geometry viewer but not in elmerGUI.
I think the reason could be meshing these small parts, as it is working when I remove the small parts from the model.
I have tried to mesh it in Salome as well, but it is not possible either. the process starts but does not finish.
Is there a way to do it better? Can I ask to Elmer to be careful with these small parts?
thank you
meshing the model
Re: meshing the model
Hi,
as Elmer's meshing capabilities are limited, I would not rely on them especially in difficult cases. Very small parts are always a challenge.
You can try to find a solution for your problem on the Salome forum, or try gmsh.
HTH,
Matthias
as Elmer's meshing capabilities are limited, I would not rely on them especially in difficult cases. Very small parts are always a challenge.
You can try to find a solution for your problem on the Salome forum, or try gmsh.
HTH,
Matthias