Gmsh error " ** On entry to DGESVD parameter number 6 had a"
Posted: 07 Mar 2018, 13:49
Hi,
I am trying to make some coil simulation and I have already made a geometric model of the coil system using Gmsh software. However, I have problems when trying to open my .geo file again. The file worked last week and i was even able to make one .mesh using gmsh, but now Gmsh only give me warning " ** On entry to DGESVD parameter number 6 had an illegal value".
Does anybody know what has gone wrong with my model and how can i overcome the problem?
The purpose of the .geo file is to generate two identical coils to same center axle and a sphere around them. At the begining of .geo, there is a few lines where user can define the dimensions of coils. I have almost the same problem with Netgen. when opening the file, Netgen gives warning "Geo-file should start with 'algebraic3d' ".
I attached .txt file of my geometry. EDIT: I added the "algebraic3d" at the beginning of the file, and then Netgen didn't show any error. However, Netgen shows nothing at all, no geometry were loaded.
-Jussi
I am trying to make some coil simulation and I have already made a geometric model of the coil system using Gmsh software. However, I have problems when trying to open my .geo file again. The file worked last week and i was even able to make one .mesh using gmsh, but now Gmsh only give me warning " ** On entry to DGESVD parameter number 6 had an illegal value".
Does anybody know what has gone wrong with my model and how can i overcome the problem?
The purpose of the .geo file is to generate two identical coils to same center axle and a sphere around them. At the begining of .geo, there is a few lines where user can define the dimensions of coils. I have almost the same problem with Netgen. when opening the file, Netgen gives warning "Geo-file should start with 'algebraic3d' ".
I attached .txt file of my geometry. EDIT: I added the "algebraic3d" at the beginning of the file, and then Netgen didn't show any error. However, Netgen shows nothing at all, no geometry were loaded.
-Jussi