Using Dakota optimisation software with Elmer

Mesh generators, CAD programs, and other tools

Using Dakota optimisation software with Elmer

Postby mark smith » 06 Dec 2016, 20:26

Hi All,
I'm looking at trying to interface Elmer with Dakota https://dakota.sandia.gov/ and wondered if anyone else is using it who might be able to offer advice?

I've already produced my own application that generates parameterized geometry using gmsh from a table of possible input parameters, meshes it runs elmer, postprocesses the results then goes to the next geometry variant. So I know what I need to do but getting it to interface with Dakota is somewhat of a mystery at the moment.

Thanks in advance
Regards
Mark
mark smith
 
Posts: 187
Joined: 26 Aug 2009, 18:20
Location: Peterborough, England

Return to External tools

Who is online

Users browsing this forum: No registered users and 2 guests