[SOLVED] Gmsh: mesh size dependent upon surface or volume
Posted: 16 Jun 2016, 12:03
Hi there!
I have a complex domain which requires few regions to be meshed with higher density. On COMSOL I was used to apply a mesh size correcting factor to the target surfaces. Gmsh seems powerful enough to allow this sort of things to be done. I tried to follow the instruction into these messages but I doesn't seem to work when I import the geometry from brep files.
Any of you guys ever needed to differentiate the mesh size in the domain? Have you been able to achieve it with Gmsh? If not, what do you use to do that?
I have a complex domain which requires few regions to be meshed with higher density. On COMSOL I was used to apply a mesh size correcting factor to the target surfaces. Gmsh seems powerful enough to allow this sort of things to be done. I tried to follow the instruction into these messages but I doesn't seem to work when I import the geometry from brep files.
Any of you guys ever needed to differentiate the mesh size in the domain? Have you been able to achieve it with Gmsh? If not, what do you use to do that?