Paraview results different from ElmerPost?
Posted: 11 Jun 2016, 18:14
Hi,
I'm thermal modeling a die on a substrate and Elmer post shows the hot spot is the heat source on the die and the substrate is 300K (boundary cond). However, in Paraview the substrate is hot at 300K and the die is a 0K ?? I'm attaching a dropbox link is here: https://www.dropbox.com/s/f1vmvobbt3qg1 ... 1.png?dl=0
Am I missing a setting on Paraview?
Thanks,
Brian
I'm thermal modeling a die on a substrate and Elmer post shows the hot spot is the heat source on the die and the substrate is 300K (boundary cond). However, in Paraview the substrate is hot at 300K and the die is a 0K ?? I'm attaching a dropbox link is here: https://www.dropbox.com/s/f1vmvobbt3qg1 ... 1.png?dl=0
Am I missing a setting on Paraview?
Thanks,
Brian