Paraview results different from ElmerPost?

Mesh generators, CAD programs, and other tools

Paraview results different from ElmerPost?

Postby bptsj » 11 Jun 2016, 18:14

Hi,
I'm thermal modeling a die on a substrate and Elmer post shows the hot spot is the heat source on the die and the substrate is 300K (boundary cond). However, in Paraview the substrate is hot at 300K and the die is a 0K ?? I'm attaching a dropbox link is here: https://www.dropbox.com/s/f1vmvobbt3qg1fh/Screenshot%202016-06-11%2008.11.51.png?dl=0

Am I missing a setting on Paraview?

Thanks,
Brian
bptsj
 
Posts: 27
Joined: 22 Sep 2012, 21:16

Re: Paraview results different from ElmerPost?

Postby raback » 12 Jun 2016, 01:27

Just a guess: you're saving results prior to calculating the solution. Look at the output on the screen to see if this is the case. -Peter
raback
Site Admin
 
Posts: 3111
Joined: 22 Aug 2009, 11:57
Location: Espoo, Finland

Re: Paraview results different from ElmerPost?

Postby bptsj » 12 Jun 2016, 02:12

SOLVED!! Thank you so much Peter for the educated guess.

I think what caused this was in the Model->Equation tab I had the Result Output tab set as active. The run log showed results getting saved prior to completion.

Thanks again,
Brian
bptsj
 
Posts: 27
Joined: 22 Sep 2012, 21:16

Re: Paraview results different from ElmerPost?

Postby raback » 12 Jun 2016, 02:40

Hi, you can activate the default ResultOutputSolve sequence for VTU output simple setting the name of the "Post File" to be *.vtu (instead of *.ep). -Peter
raback
Site Admin
 
Posts: 3111
Joined: 22 Aug 2009, 11:57
Location: Espoo, Finland


Return to External tools

Who is online

Users browsing this forum: No registered users and 1 guest