Hi,
I use Netgen 5.1 as mesh generator. I open my *.stl file and open in Netgen and than generate mesh. when i want to save the file, i choose export mesh as Elmer File and save mesh as folder. When i use elmer, and do Load project, it say "Unable to (re)mesh: no input data or mesh generator (please make sure that your input file in lower case)". What am I doing right? what is problem so i can't open the mesh file?
Can't read mesh file from Netgen
-
- Posts: 12
- Joined: 08 Nov 2013, 05:14
- Antispam: Yes
Re: Can't read mesh file from Netgen
Hi,
if your mesh file is in Elmer format, you have to use File->Load Mesh. See also ElmerGUI Manual, chapter 3.
HTH,
Matthias
if your mesh file is in Elmer format, you have to use File->Load Mesh. See also ElmerGUI Manual, chapter 3.
HTH,
Matthias