Hello,
I have a little problem with GMSH.
I want to extrude in two different directions and the result is a self intersecting surface.
Can you help me?
GMSH self intersecting surface
-
- Posts: 27
- Joined: 13 Aug 2013, 16:50
- Antispam: Yes
GMSH self intersecting surface
- Attachments
-
- eddy.geo
- (1.14 KiB) Downloaded 502 times
-
- Untitled.png
- (14.96 KiB) Not downloaded yet
Re: GMSH self intersecting surface
Hi,
you have a duplicated surface between the two slices. gmsh cannot handle that when meshing 3D. Remove volume 5 and surface 5, and redefine volume 5 using the other surfaces in the middle.
For more detailed gmsh question, you can also ask the gmsh mailing list.
HTH,
Matthias
you have a duplicated surface between the two slices. gmsh cannot handle that when meshing 3D. Remove volume 5 and surface 5, and redefine volume 5 using the other surfaces in the middle.
For more detailed gmsh question, you can also ask the gmsh mailing list.
HTH,
Matthias
Re: GMSH self intersecting surface
Hello;
I want to know if its possible to load a .stl file in gmsh?? I tried that but I only saw the mesh and couldnt saw the points, lines and surfaces...can someone help me??? thank you
I want to know if its possible to load a .stl file in gmsh?? I tried that but I only saw the mesh and couldnt saw the points, lines and surfaces...can someone help me??? thank you
Re: GMSH self intersecting surface
Hi,
you don't need to post the same question several times in different topics. See here: viewtopic.php?f=9&t=3621&start=10#p12236.
Matthias
you don't need to post the same question several times in different topics. See here: viewtopic.php?f=9&t=3621&start=10#p12236.
Matthias