Gmsh planar surface building crash
Posted: 11 Jun 2013, 15:24
Hi,
I'm new in Gmsh and in Elmer. I'm trying to build simple geometries in Gmsh,
and when I arrive at defining a planar surface by its boundaries, Gmsh crashes.
(Viewport prompt: "Select hole boundaries (if none, press 'e')"). Right after
I press 'e', it crashes. In this case, the boundaries are lines between the nodes of a triangle or
a planar square, and the selected boundaries form a closed path.
The same crash happenened when I tried Gmsh under Linux. Anybody with
experience with this? Nice program (Gmsh), though.
I'm new in Gmsh and in Elmer. I'm trying to build simple geometries in Gmsh,
and when I arrive at defining a planar surface by its boundaries, Gmsh crashes.
(Viewport prompt: "Select hole boundaries (if none, press 'e')"). Right after
I press 'e', it crashes. In this case, the boundaries are lines between the nodes of a triangle or
a planar square, and the selected boundaries form a closed path.
The same crash happenened when I tried Gmsh under Linux. Anybody with
experience with this? Nice program (Gmsh), though.