Hi,
I've a aproblem with mesh compatibility between gmsh and elemer.
I have created a simple cube with gmsh (attached -> cube_simple.msh). I'm able to open the file with Elmer without problem with (File->Open).
Now, with the same file (in gmsh) I push the button "Refine by splitting" to refine the mesh, and I create a new file (attached -> cube_simple_ref.msh). Now, I try to open this new file with Elmer obtaining (attached -> cube.jpeg).
Where is the problem?
Thanks
Ana
Problem with mesh created with gmsh
Problem with mesh created with gmsh
- Attachments
-
- cube.jpeg
- (50 KiB) Not downloaded yet
-
- cube_simple_ref.msh
- (16.39 KiB) Downloaded 358 times
-
- cube_simple.msh
- (2.9 KiB) Downloaded 372 times
-
- Site Admin
- Posts: 4823
- Joined: 22 Aug 2009, 11:57
- Antispam: Yes
- Location: Espoo, Finland
- Contact:
Re: Problem with mesh created with gmsh
Hi, Looks ok in my current ElmerGUI version. Maybe you have quite on old ElmerGUI? You could also try to translate it manually "ElmerGrid 14 2 mymesh.msh -autoclean" and the open the mesh in ElmerGUI. -Peter
- Attachments
-
- cube_simple_ref.png (16.04 KiB) Viewed 3611 times
Re: Problem with mesh created with gmsh
It works !!!!
Thanks a lot
Ana
Thanks a lot
Ana