Error importing Abaqus mesh
Posted: 15 Feb 2013, 17:05
Hi everybody!
I have a mesh created with ICEM CFD that I would like to import in Elmer.
There are several export format such as:
GEOMETRY -> IGES, DDN, Parasolid, Rhino, STL
MESH -> Abaqus, Ansys AutoDyn, Exodus, Ideas, LS-Dyne, Nastran, Patran, Radioss, FE Modeler, STL, Spectral elements
I tried Ansys y FE Modeler without any luck.
If I save in Abaqus inp format and use ElmerGrid 5 2 I get some warnings about missing elements:
Unknown element code: *ELEMENT,TYPE=S3,ELSET=GEOM_ELSET
GetElementSide: unknown elementtype 0 (elem=1,side=5)
and a segmentation fault.
If I run with the -autoclean option ElmerGrid exit correctly and an elmer mesh is created but then I cannot open the mesh in Elmer because of:
"Unknown element family (possibly not implemented)"
I attach the mesh in inp format
Thanks for any help,
Mario
I have a mesh created with ICEM CFD that I would like to import in Elmer.
There are several export format such as:
GEOMETRY -> IGES, DDN, Parasolid, Rhino, STL
MESH -> Abaqus, Ansys AutoDyn, Exodus, Ideas, LS-Dyne, Nastran, Patran, Radioss, FE Modeler, STL, Spectral elements
I tried Ansys y FE Modeler without any luck.
If I save in Abaqus inp format and use ElmerGrid 5 2 I get some warnings about missing elements:
Unknown element code: *ELEMENT,TYPE=S3,ELSET=GEOM_ELSET
GetElementSide: unknown elementtype 0 (elem=1,side=5)
and a segmentation fault.
If I run with the -autoclean option ElmerGrid exit correctly and an elmer mesh is created but then I cannot open the mesh in Elmer because of:
"Unknown element family (possibly not implemented)"
I attach the mesh in inp format
Thanks for any help,
Mario