Paraview - Results don't look right

Mesh generators, CAD programs, and other tools
Post Reply
david.bragason
Posts: 8
Joined: 13 Jan 2013, 02:40
Antispam: Yes

Paraview - Results don't look right

Post by david.bragason »

I'm a new user of Elmer as well as Paraview. My generated vtu files don't look right in Paraview, such as the example below, a solution of a Poisson eq on a course mesh. The solution should change linearly from 1 (blue) to 2 (red), as shown by the Elmer postprocessor, but Paraview shows something different. This goes for vtu files generated from the Elmer tutorials as well. The Paraview version is 3.14.1. Does this problem look familiar to anyone? Thank you.
elmer.png
elmer.png (38.72 KiB) Viewed 3391 times
paraview.png
(24.18 KiB) Not downloaded yet
david.bragason
Posts: 8
Joined: 13 Jan 2013, 02:40
Antispam: Yes

Re: Paraview - Results don't look right

Post by david.bragason »

Sorry, got it. Just needed to have the Result Output run after the simulation... Paraview was displaying an intermediate result.
Post Reply