What visualization software do you use?

Mesh generators, CAD programs, and other tools
Post Reply

What visualization software do you use?

ElmerPost
14
15%
ElmerGUI VTK postprocessor
10
11%
Paraview
41
45%
ViSit
3
3%
Mayavi
0
No votes
Gmsh
4
4%
GiD
1
1%
Matlab
8
9%
gnuplot
4
4%
Something else (please specify)
6
7%
 
Total votes: 91

raback
Site Admin
Posts: 3330
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

What visualization software do you use?

Post by raback » 05 Jan 2012, 16:01

Dear Elmer Users,

Elmer software suite includes two different tools for postprocessing. However, these are not always sufficient for the intended use. Therefore people use a large variety of different postprocessing tools. To get an overall picture of the most commonly used tools would be interesting and hence I decided to put up this poll. Also if you are using some unsupported visualialization software for which you would like to have a output format, this would be a good place to cast the votes.

-Peter

Epy
Posts: 11
Joined: 12 Nov 2012, 02:29
Antispam: Yes
Location: CA, USA
Contact:

Re: What visualization software do you use?

Post by Epy » 13 Nov 2012, 00:11

I need to start using ParaView, but for now I mostly use SALOME when I can.

fmuldoo
Posts: 2
Joined: 09 Jun 2011, 14:27
Antispam: Yes

Re: What visualization software do you use?

Post by fmuldoo » 13 Feb 2013, 20:03

I use Tecplot. Is there any way to get Elmer output into Tecplot?

Cheers,
Frank

raback
Site Admin
Posts: 3330
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

Re: What visualization software do you use?

Post by raback » 13 Feb 2013, 21:41

Hi Frank

Does Techplot read any format with publically available format specifications? Link to the specs is a good starting point for adding such features.

-Peter

Post Reply