Hi
I currently use the ResultOutputSolver to output results in GiD format & wondered if there was a method of converting this into vtk or GMSH format without running the solver again?
Regards
mark
postprocessor format conversion
-
- Posts: 215
- Joined: 26 Aug 2009, 18:20
- Location: Peterborough, England
-
- Site Admin
- Posts: 4812
- Joined: 22 Aug 2009, 11:57
- Antispam: Yes
- Location: Espoo, Finland
- Contact:
Re: postprocessor format conversion
Hi Mark
Sorry, this is not possible at least within Elmer suite. There could perhaps be some other converters between these formats but I'm not aware of such.
-Peter
Sorry, this is not possible at least within Elmer suite. There could perhaps be some other converters between these formats but I'm not aware of such.
-Peter
-
- Posts: 215
- Joined: 26 Aug 2009, 18:20
- Location: Peterborough, England
Re: postprocessor format conversion
Hi Peter
Thanks for the reply, I haven't managed to find a format converter so I suppose I'll have to write my own ;-(
I'll make it available once it's ready.
Regards
mark
Thanks for the reply, I haven't managed to find a format converter so I suppose I'll have to write my own ;-(
I'll make it available once it's ready.
Regards
mark