postprocessor format conversion

Mesh generators, CAD programs, and other tools

postprocessor format conversion

Postby mark smith » 12 Sep 2011, 17:12

Hi
I currently use the ResultOutputSolver to output results in GiD format & wondered if there was a method of converting this into vtk or GMSH format without running the solver again?
Regards
mark
mark smith
 
Posts: 187
Joined: 26 Aug 2009, 18:20
Location: Peterborough, England

Re: postprocessor format conversion

Postby raback » 13 Sep 2011, 14:24

Hi Mark

Sorry, this is not possible at least within Elmer suite. There could perhaps be some other converters between these formats but I'm not aware of such.

-Peter
raback
Site Admin
 
Posts: 3174
Joined: 22 Aug 2009, 11:57
Location: Espoo, Finland

Re: postprocessor format conversion

Postby mark smith » 14 Sep 2011, 15:50

Hi Peter
Thanks for the reply, I haven't managed to find a format converter so I suppose I'll have to write my own ;-(
I'll make it available once it's ready.
Regards
mark
mark smith
 
Posts: 187
Joined: 26 Aug 2009, 18:20
Location: Peterborough, England


Return to External tools

Who is online

Users browsing this forum: No registered users and 1 guest