Result Output in parallel

Post processing utility for Elmer
Post Reply
raven
Posts: 11
Joined: 15 Dec 2009, 11:29

Result Output in parallel

Post by raven »

Hallo,

I have a problem with the result output solver in parallel run. I use vtk to see my results in paraview. But when I use the parallel version of elmersolver on an partitioned mesh I am not be able to see the results.
Error reading ascii data. Possible mismatch of datasize with declaration.
The size of the vtk files is also smaller than on single run. I think I only get the data for one partition.

How can I use the result output solver in parallel run to see my results in paraview?

Best regards, Rene
raback
Site Admin
Posts: 3749
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

Re: Result Output in parallel

Post by raback »

Hi, only the xml vtk format (vtu format) is even supposed to work in parallel. Did you use this or the legacy format? -Peter
raven
Posts: 11
Joined: 15 Dec 2009, 11:29

Re: Result Output in parallel

Post by raven »

Hallo,

thank you for your fast answer. I used the legacy format. Now I use the xml vtk format and it works all fine.

René
Post Reply