Dear users:
When I push the button to start the postprocessor, nothing happens and the message "unable to start postprocessor" appears in the bottom part of the window. Same happens when using menu Run-> Start postprocessor.
Thank you in advance.
Unable to start postprocessor
-
- Site Admin
- Posts: 4823
- Joined: 22 Aug 2009, 11:57
- Antispam: Yes
- Location: Espoo, Finland
- Contact:
Re: Unable to start postprocessor
Hi
The new cmake based installer was lacking ElmerPost. This is not a large shortcoming since most people use Paraview anyways. The installers where updated maybe two weeks ago and should now also include ElmerPost.
-Peter
The new cmake based installer was lacking ElmerPost. This is not a large shortcoming since most people use Paraview anyways. The installers where updated maybe two weeks ago and should now also include ElmerPost.
-Peter
Re: Unable to start postprocessor
Thank you, I'll try Paraview then.
-
- Posts: 1
- Joined: 08 Aug 2015, 01:32
- Antispam: Yes
Re: Unable to start postprocessor
Is this the case?raback wrote:Hi
The new cmake based installer was lacking ElmerPost. This is not a large shortcoming since most people use Paraview anyways. The installers where updated maybe two weeks ago and should now also include ElmerPost.
-Peter
I've been unable to compile ElmerPost with cmake.