Unable to start postprocessor

Post processing utility for Elmer
Post Reply
fvarela
Posts: 5
Joined: 06 Dec 2014, 19:06
Antispam: Yes

Unable to start postprocessor

Post by fvarela »

Dear users:

When I push the button to start the postprocessor, nothing happens and the message "unable to start postprocessor" appears in the bottom part of the window. Same happens when using menu Run-> Start postprocessor.

Thank you in advance.
raback
Site Admin
Posts: 4812
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

Re: Unable to start postprocessor

Post by raback »

Hi

The new cmake based installer was lacking ElmerPost. This is not a large shortcoming since most people use Paraview anyways. The installers where updated maybe two weeks ago and should now also include ElmerPost.

-Peter
fvarela
Posts: 5
Joined: 06 Dec 2014, 19:06
Antispam: Yes

Re: Unable to start postprocessor

Post by fvarela »

Thank you, I'll try Paraview then.
sabian2008
Posts: 1
Joined: 08 Aug 2015, 01:32
Antispam: Yes

Re: Unable to start postprocessor

Post by sabian2008 »

raback wrote:Hi

The new cmake based installer was lacking ElmerPost. This is not a large shortcoming since most people use Paraview anyways. The installers where updated maybe two weeks ago and should now also include ElmerPost.

-Peter
Is this the case?

I've been unable to compile ElmerPost with cmake.
Post Reply