Page 1 of 1

Unable to start postprocessor

Posted: 07 Dec 2014, 18:10
by fvarela
Dear users:

When I push the button to start the postprocessor, nothing happens and the message "unable to start postprocessor" appears in the bottom part of the window. Same happens when using menu Run-> Start postprocessor.

Thank you in advance.

Re: Unable to start postprocessor

Posted: 07 Dec 2014, 22:27
by raback
Hi

The new cmake based installer was lacking ElmerPost. This is not a large shortcoming since most people use Paraview anyways. The installers where updated maybe two weeks ago and should now also include ElmerPost.

-Peter

Re: Unable to start postprocessor

Posted: 10 Dec 2014, 14:00
by fvarela
Thank you, I'll try Paraview then.

Re: Unable to start postprocessor

Posted: 08 Aug 2015, 16:24
by sabian2008
raback wrote:Hi

The new cmake based installer was lacking ElmerPost. This is not a large shortcoming since most people use Paraview anyways. The installers where updated maybe two weeks ago and should now also include ElmerPost.

-Peter
Is this the case?

I've been unable to compile ElmerPost with cmake.