Howdy,
I would like to show my results (elmer/N-S eqn) using more than one isosurface. Each isosurface with an opacity less than 100%such that the one behind it can be seen. However, this is the result:
Obviously that is not useable, is there any way to improve the quality of the image?
Multiple isosurfaces with opacity
-
- Site Admin
- Posts: 4828
- Joined: 22 Aug 2009, 11:57
- Antispam: Yes
- Location: Espoo, Finland
- Contact:
Re: Multiple isosurfaces with opacity
Hi
I would suggest using Paraview. ElmerPost is more or less what it is, and that does not look too good.
-Peter
I would suggest using Paraview. ElmerPost is more or less what it is, and that does not look too good.
-Peter
-
- Posts: 72
- Joined: 10 Nov 2009, 19:17
Re: Multiple isosurfaces with opacity
Peter, thankyou for your reply-I'll have a play with paraview.
Is there a reason that the above image looks so bad? some limitation on filesize or somesuch?
Is there a reason that the above image looks so bad? some limitation on filesize or somesuch?