Thank you for such a fast answer. I'm not sure what you meant with test file for Paraview, by the way I tried to attached the Test.out file that comes from ELMER without any success as .out file aren't allowed. Let me know if you need some more data.
I don't see an obvious problem in your sif file. Could you post your output file myfile.vtu? Or, if it is confidential or too large (even zipped), could you build a small test case reproducing the problem and post the vtu file?
Solver 2 Equation = Linear elasticity Exec Solver = Always ... End
Solver 1 Equation = Result Output Exec Solver = Always ... End
Equation 1 ... Active Solvers(2) = 2 1 End
Doesn't that mean that the Result Output would be called after Linear Elasticity? In any case, Exec Solver = After All is appropriate for Steady State, of course. Exec Solver = Always would mean that each iteration step is saved. At least as far as I know...
Once again, thank you for your support. As I'm newbe with Elmer, sometime I miss some parameters. Regarding GUI, the option "After All" doesn't exist. Obviously, I can change it through .sif file. Have got options : Always Before Simulation, After Simulation, Before timestep, After timestep & Never. Guess no so obvious. Then, by checking "After timestep", I suppose to define "After All", don't I?
"Always" refers to to the main iteration loop wherein the solvers are executed according to their number. Both "after timestep" and "after all" are performed after the main iteration loop. Their order again is competing with other solvers in the same "exec solver" slot.