How to simulate cross-sectional terrain using elmer?

General discussion about Elmer
Post Reply
xujiaxin
Posts: 14
Joined: 07 Oct 2018, 17:18
Antispam: Yes

How to simulate cross-sectional terrain using elmer?

Post by xujiaxin »

Hello
Figure 1, a complete topography, Figure 2 is its cross section (the picture inside the paper). I now have my own data and have made a complete terrain. Now I want to simulate a cross-sectional view. What do I need to do?
xujiaxin
Attachments
figure 2.PNG
figure 2.PNG (333.04 KiB) Viewed 4066 times
figure 1.PNG
figure 1.PNG (169.19 KiB) Viewed 4066 times
mzenker
Posts: 1999
Joined: 07 Dec 2009, 11:49
Location: Germany

Re: How to simulate cross-sectional terrain using elmer?

Post by mzenker »

Duplicate of viewtopic.php?f=21&t=6748?
If you just want to view the cross section, then you can use ParaView to do that.

HTH,

Matthias
xujiaxin
Posts: 14
Joined: 07 Oct 2018, 17:18
Antispam: Yes

Re: How to simulate cross-sectional terrain using elmer?

Post by xujiaxin »

Hello
the post you sent is also sent by me. I know that using paraview can simulate, but what specific instructions or steps are there? For example, what instructions do I need to enter at the terminal, or what is set in the .sif file?
best wishes
mzenker
Posts: 1999
Joined: 07 Dec 2009, 11:49
Location: Germany

Re: How to simulate cross-sectional terrain using elmer?

Post by mzenker »

Hi,

did you ever work with Elmer before? If not, then you should have a look at the documentation and tutorials.

Matthias
xujiaxin
Posts: 14
Joined: 07 Oct 2018, 17:18
Antispam: Yes

Re: How to simulate cross-sectional terrain using elmer?

Post by xujiaxin »

hello
ok,thanks,
best wish
Post Reply