Hello
Figure 1, a complete topography, Figure 2 is its cross section (the picture inside the paper). I now have my own data and have made a complete terrain. Now I want to simulate a cross-sectional view. What do I need to do?
xujiaxin
How to simulate cross-sectional terrain using elmer?
How to simulate cross-sectional terrain using elmer?
- Attachments
-
- figure 2.PNG (333.04 KiB) Viewed 4071 times
-
- figure 1.PNG (169.19 KiB) Viewed 4071 times
Re: How to simulate cross-sectional terrain using elmer?
Duplicate of viewtopic.php?f=21&t=6748?
If you just want to view the cross section, then you can use ParaView to do that.
HTH,
Matthias
If you just want to view the cross section, then you can use ParaView to do that.
HTH,
Matthias
Re: How to simulate cross-sectional terrain using elmer?
Hello
the post you sent is also sent by me. I know that using paraview can simulate, but what specific instructions or steps are there? For example, what instructions do I need to enter at the terminal, or what is set in the .sif file?
best wishes
the post you sent is also sent by me. I know that using paraview can simulate, but what specific instructions or steps are there? For example, what instructions do I need to enter at the terminal, or what is set in the .sif file?
best wishes
Re: How to simulate cross-sectional terrain using elmer?
Hi,
did you ever work with Elmer before? If not, then you should have a look at the documentation and tutorials.
Matthias
did you ever work with Elmer before? If not, then you should have a look at the documentation and tutorials.
Matthias
Re: How to simulate cross-sectional terrain using elmer?
hello
ok,thanks,
best wish
ok,thanks,
best wish