Turek Hron Benchmark case in Elmer (both CFD and CSM)

General discussion about Elmer
Post Reply
asandip
Posts: 92
Joined: 09 May 2019, 22:06
Antispam: Yes

Turek Hron Benchmark case in Elmer (both CFD and CSM)

Post by asandip »

Hello,

I am looking to implement the Turek Hron Benchmark case in Elmer (both CFD and CSM). Would I need to interface Elmer with OpenFOAM?

While looking for similar problems on Elmer, I found this - http://illinoisrocstar.github.io/ElmerF ... turek.html

Thank you for any suggestions you can provide.

- Anjali
mzenker
Posts: 1999
Joined: 07 Dec 2009, 11:49
Location: Germany

Re: Turek Hron Benchmark case in Elmer (both CFD and CSM)

Post by mzenker »

Duplicate of viewtopic.php?f=7&t=5390#p21003.
Please don't post the same question twice.

Matthias
asandip
Posts: 92
Joined: 09 May 2019, 22:06
Antispam: Yes

Re: Turek Hron Benchmark case in Elmer (both CFD and CSM)

Post by asandip »

Matthias,

I had posted the question under the wrong topic, so I re-posted it here. The intention was not to post it twice.

In regards to the Turek Hron Benchmark case which involves both CFD and CSM, would I need to couple Elmer with OpenFOAM?

Thank you for any information you can provide.

- Anjali
mzenker
Posts: 1999
Joined: 07 Dec 2009, 11:49
Location: Germany

Re: Turek Hron Benchmark case in Elmer (both CFD and CSM)

Post by mzenker »

Hi,

I don't know anything about the Turek Hron Benchmark.
Coupling of Elmer and OpenFoam is possible, see viewtopic.php?f=9&t=5260&p=18382 and viewtopic.php?f=3&t=4999&p=18414.

HTH,
Matthias
raback
Site Admin
Posts: 4812
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

Re: Turek Hron Benchmark case in Elmer (both CFD and CSM)

Post by raback »

Hi Anjali,

The Turek Hron benchmark is intended to be very difficult requiring special techniques. It would be a challenge to obtain convergence with any two loosely coupled software. You don't need OpenFOAM here since the fluid problem is not too difficult. It is the coupling that is the tricky part.

-Peter
asandip
Posts: 92
Joined: 09 May 2019, 22:06
Antispam: Yes

Re: Turek Hron Benchmark case in Elmer (both CFD and CSM)

Post by asandip »

Thanks, Peter, for letting me know!
Post Reply