How to set angular velocity?

General discussion about Elmer
Post Reply
Nico
Posts: 3
Joined: 10 Aug 2017, 15:59
Antispam: Yes

How to set angular velocity?

Post by Nico »

Hi.
I am working with a turbulence flow across a rotating cylinder and i am new with elmer. I do not realize how to set angular velocity. I was wondering if someone could help me. :D :D
Thanks.

(Sorry if the post is not in the correct section).
mzenker
Posts: 1999
Joined: 07 Dec 2009, 11:49
Location: Germany

Re: How to set angular velocity?

Post by mzenker »

Hi,

there is a keyword for that, see Models Manual, chapter 2.
If you use ElmerGUI, you can use the free text field in the Body Force window.

HTH,

Matthias
raback
Site Admin
Posts: 4812
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

Re: How to set angular velocity?

Post by raback »

Hi

Note that turbulence + rotating frames is probably unknown territory. There indeed exists a rotating frame for Navier-Stokes but that has not been extensively used, to my knowledge. There is a consistency test named "RotatingFlow".

-Peter
Nico
Posts: 3
Joined: 10 Aug 2017, 15:59
Antispam: Yes

Re: How to set angular velocity?

Post by Nico »

Thanks a lot for your answers.
raback wrote:Hi

Note that turbulence + rotating frames is probably unknown territory. There indeed exists a rotating frame for Navier-Stokes but that has not been extensively used, to my knowledge. There is a consistency test named "RotatingFlow".

-Peter
Ok. I found some papers online, but i am still reading to solve it. Thanks ;)
Nico
Posts: 3
Joined: 10 Aug 2017, 15:59
Antispam: Yes

Re: How to set angular velocity?

Post by Nico »

mzenker wrote:Hi,

there is a keyword for that, see Models Manual, chapter 2.
If you use ElmerGUI, you can use the free text field in the Body Force window.

HTH,

Matthias
I want to know if i am doing in the right way.
In the Boundary Conditions - Navier Stokes. I set "Use normal-tangential coordinate system", and then i put the angular velocity i wanted in Velocity 3 (z axis).
It is ok?
mzenker
Posts: 1999
Joined: 07 Dec 2009, 11:49
Location: Germany

Re: How to set angular velocity?

Post by mzenker »

I don't know, I did not use the Navier-Stokes solver yet.
If you still have questions after reading the corresponding chapter in the Models manual, then someone with more knowledge on Navier-Stokes has to take over...

Matthias
Post Reply