Elmer Solver doesn't generate Elmerpost input file

[indroneelg]

Hi,
I am just starting out with Elmer and was trying to simulate a load on a disc.
When I press the "Run ElmerSolver" button, Windows reports ElmerSolver.exe has stopped working,
in the Solver log there are a few entries and the solution looks like is converges but it does not
generate the input files for the post processor.

I don't where I am making a mistake. I would appreciate it if you could give me pointer to what I should
change. The relevant files of the project are in the attachment.

Thank you.

-Indroneel.

[mal]

Hi and welcome,

I just tried running your project on two different machines, and it worked well in both cases.

Which version of ElmerGUI/ElmerSolver are you using? The lastest Windows builds can be downloaded from nic.funet.fi My tests were based on rev 4259 from yesterday.

[indroneelg]

Hi !

I am using Elmer version 6.0 (from installation directory) and Solver 5.5.0 (what i noticed in the server log).
Is there another way to check to the version numbers ?
Just before I installed the latest build, I tried to run it again.
It worked fine and the post processor showed the results.

But I am sure it had given me the windows error and no post processor input
was generated. The convergence monitor has a different looking graph now, previously the error would occur
before the convergence graph was fully drawn.

Thanks a lot!
-Indroneel.