Page 1 of 1

Problem after adding NURBS

Posted: 07 Oct 2018, 18:39
by kanito
Dear all,
I have a problem after Run ELMERGUI.
FYI, I use GID software for structure drawing and mesh generation.
I want to get the data on the vertical boundary (as shown in the Picture : Single_NURBS-horz1.jpg ) after FEM simulation by ELMERGUI.

Therefore, I have tried to create the new NURBS (as shown in the Picture : separate_NURBS-horz1.jpg ), and used the same .sif file for ELMERGUI. (I also attached the .sif file)

The mesh was seemed to generated as I wanted. The nodes were on the vertical boundary line, however, the results were totally different.
Therefore, I want to ask you for a suggestion how can I manage with this problem?

Thank you in advance,