Problem after adding NURBS

The graphical user interface of Elmer
Post Reply
Posts: 9
Joined: 28 May 2018, 08:14
Antispam: Yes

Problem after adding NURBS

Post by kanito »

Dear all,
I have a problem after Run ELMERGUI.
FYI, I use GID software for structure drawing and mesh generation.
I want to get the data on the vertical boundary (as shown in the Picture : Single_NURBS-horz1.jpg ) after FEM simulation by ELMERGUI.

Therefore, I have tried to create the new NURBS (as shown in the Picture : separate_NURBS-horz1.jpg ), and used the same .sif file for ELMERGUI. (I also attached the .sif file)

The mesh was seemed to generated as I wanted. The nodes were on the vertical boundary line, however, the results were totally different.
Therefore, I want to ask you for a suggestion how can I manage with this problem?

Thank you in advance,
(210.31 KiB) Not downloaded yet
(208.02 KiB) Not downloaded yet
(3.22 KiB) Downloaded 158 times
Post Reply