Problem with STEP-File
Posted: 08 Sep 2018, 22:58
Hi everybody,
i build following STEP File(I also tried to build an IGES) with freecad (0.15). Other models produced by freecad work fine. But I did not find out a way to produce a mesh (or a body) in ElmerGUI. Can someone say what is wrong with this STEP file?
i build following STEP File(I also tried to build an IGES) with freecad (0.15). Other models produced by freecad work fine. But I did not find out a way to produce a mesh (or a body) in ElmerGUI. Can someone say what is wrong with this STEP file?