Problem with STEP-File

The graphical user interface of Elmer
Post Reply
Michael Schuch
Posts: 8
Joined: 10 Feb 2013, 21:33
Antispam: Yes

Problem with STEP-File

Post by Michael Schuch »

Hi everybody,
i build following STEP File(I also tried to build an IGES) with freecad (0.15). Other models produced by freecad work fine. But I did not find out a way to produce a mesh (or a body) in ElmerGUI. Can someone say what is wrong with this STEP file?
Attachments
Test.step
(202.16 KiB) Downloaded 290 times
mzenker
Posts: 1999
Joined: 07 Dec 2009, 11:49
Location: Germany

Re: Problem with STEP-File

Post by mzenker »

Elmer's meshing capabilities being limited, the recommended way is to use an external mesher like gmsh or Salome and import the mesh into ElmerGUI.

HTH,

Matthias
Post Reply