Hello everyone,
I am following the guide http://www.elmerfem.org/elmerwiki/index ... e_to_Elmer
I am trying to design two spheres. I create two spheres with salome and follow the steps, but both spheres appear as a single volume in elmerGUI. Do you know why is that happening?
Two bodies
Re: Two bodies
Hi,
did you define mesh groups in the SMESH module before exporting to unv? You can also do that using "create groups from geometry".
HTH,
Matthias
did you define mesh groups in the SMESH module before exporting to unv? You can also do that using "create groups from geometry".
HTH,
Matthias