The mesh file (2D unv) attached to this post contains the group names: Face1, Edge1 and Edge3. The Face1 group is generated just fine but the edges have weird names. Here is the mesh.names file ElmerGrid generated for me:
I think your mesh has a problem. When run with -autoclean, ElmerGrid spits errors about unknown element types. When I open your unv file with Salomé (version 7), I see that the face lies in the x-z plane. There have been problems with 2D geometries not lying in the x-y plane. So maybe rotating the face into the x-y plane could improve things.
The ordering of nodes in quadratic triangle seemed flawed. This is now fixed. It may have been related to that the BCs where not properly identified. The current "devel" version identifies also Edge1 and Edge3. Fetch it from GitHub or wait the changes to be migrated into the distributions.
raback wrote:
The ordering of nodes in quadratic triangle seemed flawed. This is now fixed. It may have been related to that the BCs where not properly identified. The current "devel" version identifies also Edge1 and Edge3. Fetch it from GitHub or wait the changes to be migrated into the distributions.