Multiple pieces, same material - differing orientations

The graphical user interface of Elmer
Post Reply
drtspc
Posts: 13
Joined: 23 May 2013, 19:45
Antispam: Yes

Multiple pieces, same material - differing orientations

Post by drtspc »

I want to use Elmer to study thermally induced stresses in grains of Cu (say).
I think I have the rotation of the anisotropic elasticity matrix working, thanks in large part to previous forum posts.

I edited the Cu entry that came with the Elmer package (in egmaterials.xml), in order to introduce the anisotropic elasticity matrix. But . . .

I have also "had to" edit egmaterials.xml - to add several varieties/names of Cu. Otherwise, one version/entry is spread to all bodies with the same name. This can make sense, but not if I want to use Cu (say) and have the same material - but with different orientations.

In short: Is adding multiple entries for the "same material" the only approach?

Thanks,
Tim
raback
Site Admin
Posts: 4812
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

Re: Multiple pieces, same material - differing orientations

Post by raback »

Hi

I think that this is not a very desired general solution. It would be nicer to define some rotation matrix someway, and let the material be intact. I remember that there has been discussions around the topic but can't remember whether there is a working solution.

-Peter
Post Reply