I would strongly encourage to write a small Fortran sniplet rather than trying to make complex expressions with MATC. It is much easier to debug proper code.
Hi,
Which one please, im looking for if it's A hollow or not,because may be the propagation not happen because there is no material inside the elastic plate, i want to know please whent i creat a surface and do translate==> extrude surface is it ful or hollow by default?
Fouzi wrote:
Which one please, im looking for if it's A hollow or not,because may be the propagation not happen because there is no material inside the elastic plate, i want to know please whent i creat a surface and do translate==> extrude surface is it ful or hollow by default?
You can find out if there is a volume in your geometry by using the corresponding items in the "geometry" tab. You can find out if there is a volumetric mesh by using the corresponding items in the "mesh" tab.
I have never used "extrude", so I cannot tell for your 2nd question.