using convergence plot

The graphical user interface of Elmer
Post Reply
mark smith
Posts: 215
Joined: 26 Aug 2009, 18:20
Location: Peterborough, England

using convergence plot

Post by mark smith »

Hi Elmer community,
I tend to run all my simulations from the command line, so I produce a mesh and partition it using elmergrid and place the partition directory in the same folder as the sif file and ELMER_STARTINFO file and then launch the application from the terminal/command line, if using windows I'd use "mpiexec -n 16 elmersolver_mpi" Now is it possible to run the same case from Elmergui just so I can take advantage of the convergence plot facility without having to load a mesh or project?

Regards
Mark
raback
Site Admin
Posts: 4812
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

Re: using convergence plot

Post by raback »

Hi Mark

You might take a look at earlier discussion on the topic
viewtopic.php?f=15&t=1662

I would think that you could also use ElmerGUI just maybe removing the pre- and postrpocessing steps related to parallel execution. Just be carefull not to save thereby overwriting the sif file.

-Peter
Post Reply